Switching Application Mode

Winshuttle Designer has two application modes that allow it to interact with Winshuttle Workflow:

• Winshuttle Workflow
• Winshuttle Workflow with SAP extensions

  Note: Winshuttle Workflow with SAP extensions requires a valid Winshuttle CENTRAL license.

When you have made the initial selection upon installation, you cannot change the application mode in Designer itself. To switch the application mode, you must reset the selection manually at the command prompt.

To change the application mode in Designer:

1. Open command prompt and go to C:\Program Files (86x)\Winshuttle\Designer
2. Run the following command:
   WFDesigner.exe –ResetApplicationMode
3. In the Application Mode Selection form that opens, select the desired application mode.